WATER DISSIPATER
AVOID AIR CONDITIONING DRIP
The WATER DISSIPATER is a new product manufactured by UTER SA designed to "ELIMINATE THE WATER PRODUCED BY SPLIT AND COMPACT AIR CONDITIONING EQUIPMENTS
Complete this form and get a budget
TECHNICAL CHARACTERISTICS
SPECIFICATIONS
-
Operates on 110/220 V.
-
Weight of the equipment with its packaging: 450 gr.
-
Dimensions: 20 cm x 9 cm x 5 cm.
-
Made with anti-flame material and fully recyclable.
-
Designed and manufactured to meet CE European standards, I.E.C and E.N standards, complying with the required safety measures.
-
It is provided with the necessary accessories for its installation, except hoses.
USEFUL DATA
-
The user must provide a 2 x 1.5 mm sheathed cable that is connected to a terminal board provided for this purpose.
-
Due to its characteristics, the installation is very simple, practical and aesthetic. Is may be hung on the wall or fixed to the air conditioning equipment with the metallic support provided.
FAQ
EVAPORATION CAPACITY: 1.5L/h. (The water produced by individual Air Conditioning Equipment, SPLIT AND COMPACT, is approximately 0.7L/h at 1L/h).
THE WATER DISSIPATER was designed to enable the coupling of 2 or more units, and in this way it PROPORTIONALLY INCREASES THE EVAPORATION CAPACITY.
Easy and practical installation.
It provides a great solution to the problem of the condensed water produced by air conditioning equipments, with or without heat pump.
Operation is simple, and also has minimal maintenance. It is a container made of fireproof plastic and protected against degradation from sunlight, with UV protection.
Inside this container there is an electric open circuit, where the water enters from the air conditioner, so the circuit closes and produces electrolysis, dissociating water molecules, which heats water and it evaporates.
Consumption:
It may seem that consumption of the Water Dissipater must be very high, but nothing could be further from the truth. In the tests that had been done in laboratory, with an air conditioner of 3330 fg/h. and under normal conditions, the average consumption is 1.5 amperes (operation of the compressor, with a minimum of 0 amperes picks up 4 amperes)
Recommendations:
It is recommended that an authorized installer makes the installation of the Water Dissipater.
We also recommend that the Water Dissipater is installed outside the home (interior courtyard, balconies, exterior walls, etc.).
It should never be installed inside the house.
This avoids the re-entry of the moisture expelled by the air conditioning inside the house, which would make a vicious circle, and would not reduce the energy expenditure, produced by the increasingly small amount of moisture inside the housing produced by the air conditioner.
Designed and approved in compliance with the CE rules of the European Community and the IEC 60335
HOW DOES IT WORK ?
Entry of the water from
the air conditioner
Energy Supply
